This page is actually a small piece of a much larger site called SciLog.com
You most likely got here from a search engine or other link... that's fine when you're done just head over to the main site. Or if you think there is a problem contact us.
LabTec Specs
Dimensions: Width: 5.75 in (14.6cm); Height: 8.5 in (212.6); Depth: 11in (27.9).
Weight: 14 lbs (6.4kg)
Enclosure: 16 Ga, aluminum baked epoxy blue
LabTec Models: Optimal range for precision and speed of dispensing:
LabTec CP-120: 0.2 ml to 50 ml aliquots of low viscosity, aqueous liquids. Typical precision 0.5% by vol. Tandem 1081 peristaltic pump head with variable speed max. 160 RPM motor
LabTec CP-200: 10 ml to 2 liter aliquots of low or high viscosity liquids. Typical precision 0.5% by vol. Use with any thick, viscous liquids. Tandem 1082 peristaltic pump head with variable speed max. 600 RPM motor.
LabTec MP-320: 4 ml to 3 liter aliquots of organic solvents, low viscosity. Typical precision 0.5% by vol. liquids. Magnetic gear head, 316SS chamber with Teflon gears with variable speed max. 3400 RPM motor
Re-Cal Feature: Factory installed calibration curve for all tubing sizes. Front panel Re-cal key for single-point pump recalibration.
LabTec™ Balance Options:
Balance with capacity of 2,000 grams x 0.01 g and 8,100 g x 0.1 resolution are most popular.
Larger balance capacities up to 30 Kg x 0.1 g resolution available.
LabTec™ Software:
Dispenses by volume, rapidly and with high precision
Dispenses by weight, used with balance for rapid high precision filling by weight
Weight ratio, automates weighing and diluting process and sample prep process
Monitors back pressure of in-line sterilizing filters
Alarms when back pressure of in-line sterilizing filter is plugged up and can no longer be used.
Pressure Range: Maximum pressure output at tandem peristaltic pump head is 45 psi. Has single point recalibration feature.
Pressure Displayed: Pressure displayed with a resolution of 0.1 psi; choice of bar, psi, kpa
Pressure Sensors Options: Use with sterilizing filters to monitor filter back pressure and to alarm when need to change filter due to plugging up of filter.
Documentation Software for PC:
SciDoc interface software with custom macros for Excel for data compilation. Sent to you ready to use.
Complete process analysis with graphing of data.
Real-time verification and documentation of process parameters.
I/O Ports:
First serial port labeled Balance, Male DB9 connector for hook-up of electronic scale.
Second Serial Port labeled "Printer", Female DB9; also used to interface to PC for data storage in an Excel file in your PC.
External I/O port, Female DB37 connector; Used for remote On/Off control of FilterTec via footswitch.
Optional pressure sensor interface available
Data Entry: Membrane keyboard with auditory feedback.
LabTec Settings:
Save 10 Optimized Dispensing by Volume settings for rapid, high precision filling, from ml to liter aliquots; Typical precision of 0.5% by volume.
Save 10 Optimized Dispensing by Weight settings for rapid, high precision filling by weight from grams to kilograms aliquots; Typical precision of 0.3% by weight.
Save 10 Optimized Weight Ratio settings to automate the weighing and diluting process in sample preparation; Typical precision of 0.3% or better.
Document each dispense or dilution for GLP or for inventory control; print out or data sent to spreadsheet in PC. (SciDoc feature)